Question Paper: Computer Aided Engineering Drawing : Question Paper Jan 2015 - First Year Engineering (C Cycle) (Semester 1) | Visveswaraya Technological University (VTU)
0

## Computer Aided Engineering Drawing - Jan 2015

### First Year Engineering (C Cycle) (Semester 1)

TOTAL MARKS: 100
TOTAL TIME: 3 HOURS
(1) Question 1 is compulsory.
(2) Attempt any four from the remaining questions.
(3) Assume data wherever required.
(4) Figures to the right indicate full marks.
1(a)(i) A point is lying on HP, 20 mm behind VP an d 25 mm in front of RPP. Draw its projections and name the side view. (10 marks) 1(a)(ii) line AB measuring 70 mm has its end A15 mm in front of VP and 20 mm above HP and the other end B 60 mm in front of VP a nd 50 mm above HP. Draw the projections of the line and find the inclinations of the line with the both the reference planes of projection(20 marks) 1(b) A pentagonal lamina of edges 25mm is resting on HP with one of its corners such that the edge opposite to this corner is 20mm above HP and makes an angle of 45° with VP. Draw the top and front views of the lamina in this position. Determine the inclination of the lamina with HP(30 marks) 2 A tetrahedron of sides 40mm is resting on one ofits sides on HP. This side is parallel to VP and 40mm away from it. It is tilted about resting side such that the base containing this edge is inclined at 30°to HP. Draw the projections of the solid. (40 marks) 3(a) A regular pentagonal pyramid of side of base 35mm and altitude 65mm has its base on HP with a side of base perpendicular to VP.The pyramid is cut by a section plane which is perpendicular to VP and inclined at 30° to HP. The cutting plane meets the axis of the pyramid at a point 30mm below the apex. Draw the development of the remaining part of the pyramid. (30 marks) 3(b) A regular pentagonal prism of base sides 30mm and axis 60 mm is mounted centrally over a cylindrical block of 80mm diameter and 25mm thick. Draw theisometric projection of the combined solids. (30 marks)