0
8.9kviews
What is the use of front porch and back porch in the composite video signal?
1 Answer
0
567views

Front porch:

  • This is a brief cushioning period of 1.5 µs inserted between the end of the picture detail for that line and the leading edge of the line sync pulse.
  • This interval allows the receiver video circuit to settle down from whatever picture voltage level exists at the end of the picture line to the blanking level before the sync pulse occurs.
  • Thus sync circuits at the receiver are isolated from the influence of end of the line picture details. The most stringent demand is made on the video circuits when peak white detail occurs at the end of a line.
  • Despite the existence of the front porch when the line ends in an extreme white detail, and the signal amplitude touches almost zero level, the video voltage level fails to decay to the blanking level before the leading-edge of the line sync pulse occurs.
  • This results in late triggering of the time base circuit thus upsetting the ‘horz’ line sync circuit. As a result the spot (beam) is late in arriving at the left of the screen and picture information on the next line is displaced to the left. This effect is known as ‘pulling-on-whites’.

enter image description here

Back porch:

  • This period of 5.8 µs at the blanking level allows plenty of time for line flyback to be completed. It also permits time for the horizontal time-base circuit to reverse direction of current for the initiation of the scanning of next line.
  • Infact, the relative timings are so set that small black bars as shown in diagram are formed at both the ends of the raster in the horizontal plane. These blanked bars at the sides have no effect on the picture details reproduced during the active line period.
  • The back porch also provides the necessary amplitude equal to the blanking level (reference level) and enables to preserve the dc content of the picture information at the transmitter.
  • At the receiver this level which is independent of the picture details is utilized in the AGC (automatic gain control) circuits to develop true AGC voltage proportional to the signal strength picked up at the antenna.
Please log in to add an answer.