2
38kviews
Explain Minimum mode of 8086 microprocessor. Draw timing diagram for write operation in minimum mode and explain it.
1 Answer
11
685views
  • 8086 works in Minimum Mode, when MN/ ¯MX = 1.
  • Minimum Mode, 8086 is the only processor in the system. The Minimum Mode circuit of 8086 is as shown below:
  • Clock is provided by the 8284 clock generator, it provides CLK, RESET and READY input to 8086.
  • Address from the address bus is latched into 8282 8-bit latch. Three such latches are needed, as address bus is 20-bit. The ALE of 8086 is connected to STB of the latch. The ALE for this latch is given by 8086 itself.
  • The data bus is driven through 8286 8-bit trans-receiver. Two such trans-receivers are needed, as the data bus is 16-bit. The trans-receivers are enabled through the DEN signal, while the direction of data is controlled by the DT/ ¯R signal. ¯DEN is connected to ¯OE and DT/ ¯R is connected to T. Both ¯DEN and DT/ ¯R are given by 8086 itself.

enter image description here

  • Control signals for all operations are generated by decoding M/¯IO , ¯RD and ¯WR signals.

enter image description here

  • M/¯IO , ¯RD and ¯WR are decoded by a 3:8 decoder like IC 74138. Bus Request (DMA) is done using the HOLD and HLDA signals.
  • ¯INTA is given by 8086, in response to an interrupt on INTR line.

Minimum Mode configuration of 8086

Minimum Mode Write Cycle

Please log in to add an answer.

Continue reading...

The best way to discover useful content is by searching it.

Search