0
26kviews
Explain the terms : selectivity, fidelity, sensitivity, AGC.

Mumbai University > Electronics > Sem 4 > Priniciples of Communication Engineering

1 Answer
3
1.2kviews

(i) Selectively

enter image description here

Fig1: Selectivity

  • The selectivity of an AM receiver is defined as its ability to accept or select the desired band of frequency and reject all other unwanted frequencies which can be interfering signals.
  • Adjacent channel rejection of the receiver can be obtained from the selectivity parameter. Response of IF section, mixer and RF section considerably contribute towards selectivity.
  • The signal bandwidth should be narrow for better selectivity.
  • Graphically selectivity can be represented as a curve shown in Fig1. below, which depicts the attenuation offered to the unwanted signals around the tuned frequency.

(ii) Fidelity

  • Fidelity of a receiver is its ability to reproduce the exact replica of the transmitted signals at the receiver output.
  • For better fidelity, the amplifier must pass high bandwidth signals to amplify the frequencies of the outermost sidebands, while for better selectivity the signal should have narrow bandwidth. Thus a trade off is made between selectivity and fidelity.
  • Low frequency response of IF amplifier determines fidelity at the lower modulating frequencies while high frequency response of the IF amplifier determines fidelity at the higher modulating frequencies.

(iii) Sensitivity

enter image description here

Fig2: Sensitivity curve

  • Sensitivity of a receiver is its ability to identify and amplify weak signals at the receiver output.
  • It is often defined in terms of voltage that must be applied to the input terminals of the receiver to produce a standard output power which is measured at the output terminals.
  • The higher value of receiver gain ensures smaller input signal necessary to produce the desired output power.Thus a receiver with good sensitivity will detect minimum RF signal at the input and still produce utilizable demodulated signal.
  • Sensitivity is also known as receiver threshold. It is expressed in microvolts or decibels.
  • Sensitivity of the receiver mostly depends on the gain of IF amplifier. It can be improved by reducing the noise level and bandwidth of the receiver.
  • Sensitivity can be graphically represented as a curve shown in Fig2. Below, which depicts that sensitivity varies over the tuning band.

(iv) AGC

  • Automatic gain control (AGC) is a mechanism wherein the overall gain of the radio receiver is automatically varied according to the changing strength of the received signal. This is done to maintain the output at a constant level.
  • AGC facilitates tuning to varying signal strength stations providing a constant output. AGC smoothens the amplitude variations of the input signal and the gain control does not have to be recalibrated every time the receiver is tuned from station to station.
  • An AGC which is not designed correctly can lead to considerable distortion to a smooth signal.
  • There are two types of AGC circuits:

i. Simple AGC: the gain control mechanism is active for high as well as low value of carrier voltage.

ii. Delayed AGC: AGC bias is not applied to the amplifiers until signal strength crosses a predetermined level, after which AGC bias is applied.

Please log in to add an answer.