Basic Electronics : Question Paper Jun 2013 - First Year Engineering (C Cycle) (Semester 1) | Visveswaraya Technological University (VTU)

Basic Electronics - Jun 2013

First Year Engineering (C Cycle) (Semester 1)

(1) Question 1 is compulsory.
(2) Attempt any four from the remaining questions.
(3) Assume data wherever required.
(4) Figures to the right indicate full marks.

Choose the correct answer:

1 (a) (i) When forward-biased, a diode
a) blocks current
b) conducts current
c) has a high resistance
d)drops a large voltage
(1 marks)
1 (a) (ii) The knee voltage of a Silicon diode is:
a) 0.3V
b) 0.5V
c) 0.7V
d) None of these
(1 marks)
1 (a) (iii) The ripple factor of half wave rectifier is about?
a) 40.6
b) 0.46
c) 1.21
d) 81.2
(1 marks)
1 (a) (iv) The RMS value of a load current in case of a full wave rectifier is:
a) ?/2
b) Im/2
c) Im/?2
d) Im/?
(1 marks)
1 (b) Deduce the following for HWR.
i) Irms
ii) IDC
(4 marks)
1 (c) With a neat circuit diagram, explain the working principles of a full wave bridge rectifier.(6 marks) 1 (d) Draw the circuit of full wave rectifier and show that the ripple factor=0.48 and efficiency=81%.(6 marks)

Choose the correct answer:

2 (a) (i) The current relationship between two current gain in a transistor is:
a) ?=?/(1-?)
b) ?=(1+?)/(1-?)
c) ?=(1-?)/(1+?)
d) ?=(?+1)/?
(1 marks)
2 (a) (ii) The ?DC of a transistor is its:
a) current gain
b) voltage gain
c) power gain
d) internal resistance
(1 marks)
2 (a) (iii) In a transistor the current conduction is due to _____ carriers.
a) Majority
b) Minority
c) Both A&B
d) None of these
(1 marks)
2 (a) (iv) In a transistor circuit:
a) IE = IC
b) IE > IC
c) IE < IC
d) IE << IC
(1 marks)
2 (b) Draw input and output characteristics of an NPN transistor in common base configuration and explain.(8 marks) 2 (c) Calculate the value of IC, IE and ?DC for a transistor with ?=0.99 and IB=110�A.(4 marks) 2 (d) Obtain the relationship between '?DC' and '?DC'.(4 marks)

Choose the correct answer:

3 (a) (i) The intersection of a DC load line and the output characteristics of a transistor is called:
a) Q-Point
b) Quiescent point
c) Operating point
d) All of these
(1 marks)
3 (a) (ii) For an emitter follower, the voltage gain is:
a) Unity
b) Greater than unity
c) Less than unity
d) Zero
(1 marks)
3 (a) (iii) The best biasing stability is achieved by using _____ biasing circuit.
a) Fixed
b) Collector to base
c) Voltage divider
d) None of these
(1 marks)
3 (a) (iv) In self bias or emitter bias ciruit _____ is connected between emitter and ground.
a) Inductor
b) Transformer
c) Resistor
d) Capacitor
(1 marks)
3 (b) Explain the concept of base bias techniques using NPN transistor.(10 marks) 3 (c) Calculate the Q-point values for the circuit of collector to base circuit. Given RB=100k?, RC=10k?, Vcc=12V and ?DC=100.(6 marks)

Choose the correct answer:

4 (a) (i) SCR has _____ number of layers.
a) One
b) Two
c) Three
d) Four
(1 marks)
4 (a) (ii) The minimum point in VI characteristic of UJT is known as _____ point.
a) Negative
b) Valley
c) Latching
d) Conducting
(1 marks)
4 (a) (iii) The FET is a _____ controlled device.
a) Current
b) Voltage
c) Power
d) None of these
(1 marks)
4 (a) (iv) The relaxation oscillator uses:
b) SCR
c) BJT
d) UJT
(1 marks)
4 (b) Draw the two transistor equivalent circuit of SCR. Also plot V-I characteristics and explain various regions of operations.(10 marks) 4 (c) Explain with suitable diagram and waveform how UJT can be used as a relaxation oscillator.(6 marks)

Choose the correct answer:

5 (a) (i) Oscillator uses _____ type of feedback.
a) Positive
b) Negative
c) Both A&B
d) None of these
(1 marks)
5 (a) (ii) A phase shift oscillator has:
a) Three RC circuits
b) Three LC circuits
c) T-type circuit
d) ?-type circuit
(1 marks)
5 (a) (iii) The frequency of a Hartley oscillator is f= _____
a) 1/2??(LC)
b) 1/2??(RC)
c) 1/2??C
d) 1/2?LC
(1 marks)
5 (a) (iv) The upper and lower critical frequencies are sometimes called the
a) Power frequencies
b) Half power frequencies
c) 6 dB points
d) None of these
(1 marks)
5 (b) Explain with a neat diagram, the working of a single stage RC couple amplifiers with its frequency response.(8 marks) 5 (c) Give any four advantages of negative feedback in an amplifier.(4 marks) 5 (d) In a Colpitt's oscillator, if the desired frequency is 800 kHz, determine values of L and Ceq if C1=C2=10pF.(4 marks)

Choose the correct answer:

6 (a) (i) The CMRR is given by _____
a) Ad×Ac
b) Ac / Ad
c) Ad / Ac
d) 20 log Ac / Ad
(1 marks)
6 (a) (ii) The gain of the inverting amplifier using Rf=10k? and R1= 1k? is _____
a) -10
b) -11
c) 10
d) 11
(1 marks)
6 (a) (iii) The gain of voltage follower is _____
a) Zero
b) Infinite
d) Unity
(1 marks)
6 (a) (iv) The screen of CRT is coated with:
a) Chromium
b) Phosphor
c) Carbon
d) Germanium
(1 marks)
6 (b) Calculate the output voltage of a three input summing amplifier:
(6 marks)
6 (c) Show how an op-amp can be used as an integrator. Derive an expression for output voltage.(6 marks) 6 (d) Give any four applications of CRO.(4 marks)

Choose the correct answer:

7 (a) (i) The modulating frequency is _____ carrier frequency.
a) lower than
b) higher than
c) equal to
d) none of these
(1 marks)
7 (a) (ii) The modulation is done in _____
a) Transmitter
b) Receiver
c) None of the above
d)Between transmitter and receiver
(1 marks)
7 (a) (iii) The 2's complement of 1010 gives:
a) 1111
b) 0110
c) 0010
d) 0101
(1 marks)
7 (a) (iv) In binary numbers, shifting the binary point one place to the right:
a) divides by 2
b) decreases by 10
c) increases by 10
d) multiplies by 2
(1 marks)
7 (b) With suitable block diagram explain function of super heterodyne receiver.(8 marks) 7 (c) Convert (ABCD)16=( )2=( )8=( )10=( )BCD(4 marks) 7 (d) Subtract (28)10-(19)10 using both 1's complement and 2's complement methods.(4 marks)

Choose the correct answer:

8 (a) (i) When deMorgan's theorem is applied to (A+B)', we get _____
a) A+B
b) A'B'
c) A
d) B
(1 marks)
8 (a) (ii) Y=A'B+B'A is a Boolean expression for:
a) EX-OR
d) None of these
(1 marks)
8 (a) (iii) The example for universal gate is _____
a) NOT
b) NOR
c) OR
d) AND
(1 marks)
8 (a) (iv) The expression for half adder carry 'C' with inputs 'A' and 'B' is given by:
a) A+B
b) AB
c) A'B'
d) None of these
(1 marks)
8 (b) i) Realize the NAND gate using minimum number of NOR gates.
ii) Simplify M=XYZ + XY'Z+ Z'XY and realize using NOR gates.
(8 marks)
8 (c) Realize a full adder using two half adders and an OR gate with truth table.(8 marks)


Next up

Read More Questions

If you are looking for answer to specific questions, you can search them here. We'll find the best answer for you.


Study Full Subject

If you are looking for good study material, you can checkout our subjects. Hundreds of important topics are covered in them.

Know More