written 6.8 years ago by |
Industrial Electronics - Dec 2015
Mechanical Engineering (Semester 4)
TOTAL MARKS: 80
TOTAL TIME: 3 HOURS
(1) Question 1 is compulsory.
(2) Attempt any three from the remaining questions.
(3) Assume data if required.
(4) Figures to the right indicate full marks.
Answer any five.
1 (a) Draw characteristics of SCR, Triac, MOSFET and IGBT.(4 marks)
1 (b) Draw connection of an LED and a switch to MSP430.(4 marks)
1 (c) Explain basic principle of single phase inverter.(4 marks)
1 (d) Enlist characteristics of ideal op-amp.(4 marks)
1 (e) Give an example of analog circuit, digital circuit, combinational circuit and sequential logic circuit.(4 marks)
1 (f) Draw torque-speed characteristics of DC shunt motor and 3-phase induction motor.(4 marks)
1 (g) What do you understand by R-L and R-L-E load?(4 marks)
2 (a) Explain in brief functional block diagram of MSP430.(7 marks)
2 (b) Draw and explain block diagram of closed loop speed control of DC motor. Also state need of inner current loop.(7 marks)
2 (c) Draw and explain any one application circuit of Triac-Diac.(6 marks)
3 (a) Explain 555 monostable multivibrator.(7 marks)
3 (b) Explain frequency control scheme of 3-phase induction motor with the help of block diagram.(7 marks)
3 (c) Write a short note on: Forced turn-off of SCR.(6 marks)
4 (a) Draw the circuit diagram of differentiator and integrator; write the output equation of each.(7 marks)
4 (b) Enlist triggering methods of SCR and explain any one gate triggering method of SCR.(7 marks)
4 (c) What do you understand by a Digital circuit? Elaborate following terms regarding digital circuits:-
i) logic level
ii) noise immunity
iii) propagation delay
iv) power dissipation
v) fan out.(6 marks)
5 (a) Elaborate:- accuracy, resolution and least significant bit regarding 10-bit ADC.(7 marks)
5 (b) Write a short note on 'selection of motor and power rating for a pump'.(7 marks)
5 (c) Explain asymmetrical semi controlled converter with R load and derive equation of output voltage.(6 marks)
6 (a) Compare: BLDC motor, DC and induction motor.(7 marks)
6 (b) Compare: Microprocessor and Microcontroller.(7 marks)
6 (c) Compare: TTL and CMOS technology.(6 marks)