There are many fixture components for milling machines. This section covers some of the most common.

Subplates and Angle Plates

A Subplate is a ground aluminum plate that bolts to the top of the machine table. It has threaded holes and bushings at regular intervals. Subplates protect the machine table and speeds setups by allowing clamps and other components to be quickly and precisely located anywhere in the workspace. Once installed, the subplate generally remains permanently fixed on the table. Fixtures and vises are installed on top of it.

An Angle plate is a precision ground steel plate that allows the part to be set on its side. Angle plates can point in a direction parallel to either the X or Y axis.

Figure: Angle Plate and Sub Plate

Clamps

There are literally thousands of types, styles, and sizes of clamps available. They are inexpensive, reusable, and versatile. You tool cabinet should include many types and sizes of clamps and accessories.

Figure: Clamps and Accessories

• Strap Clamps exert downward pressure on the part. They are usually secured to the table by a special bolt that can be positioned anywhere along the T-¬‐slots in the table. One end of the clamp rests on the part, and the other on a step block. To prevent galling an aluminum part, place a pad of aluminum between the clamp and part.
• Step blocks have grooves that allow them to be stacked to different heights. Step blocks are used to support one end of the strap clamp.
• Step Clamps are similar to Strap clamps, but include grooves that interlock with a single step block.
• Toe Clamps bolt to the machine table. The nose of the clamp includes grooves to grip the part. It is extended by turning a screw, forcing the clamp against the part and downward.
• Toggle Pliers are similar to hardware store vise grip pliers.

Shoulder Bolts and Dowel Pins

Dowel pins are used to precisely locate a part. They include a small chamfer to make insertion easier. Shoulder bolts both locate and grip the part. The ground shoulder on the bolt slides into a counterbore in the fixture.

Figure : Dowel Pin and Shoulder Bolt

Vise and Accessories

The CNC vise is precision engineered and manufactured with components ground flat and perpendicular to within .0002 inches. The most common is referred to as a six inch vise, because the width of the jaws is six inches.

Once the vise is bolted to the table and aligned, parts are loaded into the vise and clamped by closing the jaws. The vise can exert tremendous force, so care is taken not to over-¬‐tighten the vise and deform fragile parts. Vise pressure must be appropriate to the part being held and expected cutting forces.

Figure : Vise and Accessories

The Fixed Jaw remains stationary. The Moving Jaw opens when the Vise Handle is turned. It is a good practice to remove the vise handle after the jaws are closed and before running the program. This is done by simply sliding the handle off.

A Vise Stop is a device that allows the parts to be loaded into the vise precisely. This image shows a style of vise stop that is particularly useful because it is adjustable up-¬‐down and left--‐right.

Hard Jaws are made of hardened steel and precision ground on all sides. They are usually used along with parallels.

Parallels are thin steel plates, available in various widths, used to set the grip length of the vise jaws.

Figure 5: Hard Jaws

Step jaws are similar to hard jaws but include a step feature that eliminates the need for parallels.

Figure 6: Step Jaws

Soft jaws are blanks of aluminum used to grip parts that cannot be held using hard jaws. A cutout the same shape as the part is machined into the soft jaws to grip irregular shapes.

When machining the cutout, place a bar between the jaws to set the correct spacing. Use a torque wrench or mark the vise so it can be closed with the exact same pressure each time a new part is loaded. Remove the spacer before clamping the part.

Figure : Machining Soft Jaws