0
What are the types of pipeline hazards? or List and explain various data dependencies, data and branch hazards that occur in the computer system
0  upvotes
2
  1. Pipeline hazards are situations that prevent the next instruction in the instruction stream from executing during its designated clock cycles.
  2. Any condition that causes a stall in the pipeline operations can be called a hazard.
  3. There are primarily three types of hazards:

    i. Data Hazards

    ii. Control Hazards or instruction Hazards

    iii. Structural Hazards.

    i. Data Hazards: A data hazard is any condition in which either the source or the destination operands of an instruction are not available at the time expected in the pipeline. As a result of which some operation has to be delayed and the pipeline stalls.

    Whenever there are two instructions one of which depends on the data obtained from the other.

    A=3+A

    B=A*4

    For the above sequence, the second instruction needs the value of ‘A’ computed in the first instruction.

    Thus the second instruction is said to depend on the first.

    If the execution is done in a pipelined processor, it is highly likely that the interleaving of these two instructions can lead to incorrect results due to data dependency between the instructions. Thus the pipeline needs to be stalled as and when necessary to avoid errors.

    ii. Structural Hazards:

    This situation arises mainly when two instructions require a given hardware resource at the same time and hence for one of the instructions the pipeline needs to be stalled.

    The most common case is when memory is accessed at the same time by two instructions. One instruction may need to access the memory as part of the Execute or Write back phase while other instruction is being fetched. In this case if both the instructions and data reside in the same memory. Both the instructions can’t proceed together and one of them needs to be stalled till the other is done with the memory access part. Thus in general sufficient hardware resources are needed for avoiding structural hazards.

    iii. Control hazards:

    The instruction fetch unit of the CPU is responsible for providing a stream of instructions to the execution unit. The instructions fetched by the fetch unit are in consecutive memory locations and they are executed.

    However the problem arises when one of the instructions is a branching instruction to some other memory location. Thus all the instruction fetched in the pipeline from consecutive memory locations are invalid now and need to removed(also called flushing of the pipeline).This induces a stall till new instructions are again fetched from the memory address specified in the branch instruction.

    Thus the time lost as a result of this is called a branch penalty. Often dedicated hardware is incorporated in the fetch unit to identify branch instructions and compute branch addresses as soon as possible and reducing the resulting delay as a result.

2  upvotes
Please log in to add an answer.

Next up

Read More Questions

If you are looking for answer to specific questions, you can search them here. We'll find the best answer for you.

Search

Study Full Subject

If you are looking for good study material, you can checkout our subjects. Hundreds of important topics are covered in them.

Know More