Aksh_31
Aksh_31 • 1.5k
- Title:
- User
- Status:
- Trusted
- Email:
- 19******@gmail.com
- Location:
- India/Delhi/Delhi University
- Last seen:
- 2 years, 3 months ago
- Joined:
- 4 years, 7 months ago
Academic Profile
Expert on the subjects
No subjects here! Add a few by editing your Academic Profile.
Popular Posts by Aksh_31
<prev
• 5 results •
page 1 of 1 •
next >
Latest awards to Aksh_31
Popular Question
2.3 years ago,
created a question with more than 1,000 views.
For Write a short note on specific speed of turbine
Popular Question
2.3 years ago,
created a question with more than 1,000 views.
For A pelton wheel is to be designed for the following specification :
Popular Question
2.3 years ago,
created a question with more than 1,000 views.
For An inward flow reaction turbine has internal and external diameters ad 0.45 m and 0.9m respectively. The turbine is running at 200 rpm and width of turbine at inlet is 200 mm.
Popular Question
2.3 years ago,
created a question with more than 1,000 views.
For A hub diameter of Kaplan turbine working under head of 14 m is 0.35 times the diameter of the runner. The turbine is running at 100 rpm.
Popular Question
2.3 years ago,
created a question with more than 1,000 views.
For The propeller reaction turbine of runner diameter 4.5m is running at 40 r.p.m. The guide blade angle at inlet is $145^\circ$ and the runner blade angle at the outlet is $25^\circ$ to the direction of
Popular Question
2.3 years ago,
created a question with more than 1,000 views.
For A conical draft tube having inlet and outlet diameter 1 m and 1.5 m discharge water at outlet with a velocity of 2.5 m/s. The total length of the draft tube is 6m and 1.3m of the length of draft tube
Popular Question
2.3 years ago,
created a question with more than 1,000 views.
For What is priming and why it is necessary
Popular Question
2.3 years ago,
created a question with more than 1,000 views.
For A centrifugal pump is running at 1000 rpm. The outlet vane angle of the impeller is $45^\circ $ and the velocity of flow at the outlet is 2.5 m/s
Popular Question
2.3 years ago,
created a question with more than 1,000 views.
For Find the power required to drive a centrifugal pump which delivers $0.05 m^3/s $ of water to a height of 20 m through a 15 cm pipe and 100m long.
Popular Question
2.3 years ago,
created a question with more than 1,000 views.
For Two geometrically similar pumps are running at same speed at 1000 rpm. One pump has an impeller diameter of 0.30m and lifts water at the rate of 20 lit/s against a head of 15 m.